Z Series E85 M roadst (S54) ROADST
Inlet side:
Note:
Bearing caps are marked E2 to E7.
Install bearing caps E2 to E7.
Inlet side:
Align bearing caps by hand until they are secured by means of
adapter sleeves.
Insert all nuts of bearing caps on inlet camshaft.
Manually tighten bearing cap nuts and then tighten down from
inside to outside in 1/2 turn increments.
Tightening torque 11 31 1AZ .
Remove special tool 11 4 380 .
Inlet side:
Important!
Note direction and angle of rotation.
Rotate inlet camshaft at hexagon from horizontal position upwards
until locating bore (1) in camshaft is vertical.
Important!
Pay attention to installation direction of special tool
11 9 130 .
(A) Exhaust side
(E) Inlet side
RA Replacing camshafts (S54)
BMW AG - TIS
06.02.2013 19:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
