Z Series E85 M roadst (S54) ROADST
Inlet side:
Important!
Pay attention to installation direction of special tool
11 9 130 .
Attach special tool 11 9 130 to cylinder head. Align inlet
camshaft at hexagon until special tool 11 7 342 can be joined
by means of special tool 11 9 130 in locating bore.
special tool 11 9 130 must rest flat on cylinder head. Remove
special tool 11 7 342 .
Exhaust side:
Align exhaust camshaft at hexagon until special tool 11 7 342
can be joined by means of special tool 11 9 130 in locating
bore.
Special tool 11 9 130 must rest flat on cylinder head.
Remove special tool 11 9 130 and special tool 11 7 342 .
Lift timing chain and hold under tension.
Rotate crankshaft from 30
°
before TDC position in direction of
rotation up to TDC firing position. Secure vibration damper in
position with special tool 11 2 300 .
Hold timing chain under tension.
Position tapped holes of thrust washer horizontally as shown in
illustration.
Install sprocket wheel (2) on inlet side on centering sleeves in
such a way that elongated holes are centrally located.
Note:
The position of the elongated holes is only important in terms of
accessibility to the screws and does not affect operation in any
way.
RA Replacing camshafts (S54)
BMW AG - TIS
06.02.2013 19:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 19 -
