Z Series E85 M roadst (S54) ROADST
Release screw and remove manifold support (1).
Installation:
To avoid manifold torsion stress, secure manifold support with
screw but do not tighten down screw. Only tighten down screw
when manifold is mounted on throttle assembly.
Release screws and remove cable duct (1).
Unclip plugs (1) for monitor sensors and exhaust temperature
sensor from holders and detach.
Disconnect plug for reversing light switch from transmission.
Unfasten screws.
Open cover (1) of electronics box and remove.
Installation:
Make sure that cover is correctly inserted in hinges of electronics
box lower section (watertightness).
RA Replacing wiring harness section for engine (S54)
BMW AG - TIS
06.02.2013 21:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
