Z Series E85 M roadst (S54) ROADST
Unfasten nut.
Unlock plugs (1) and disconnect.
Unlock carrier plate (2) and pull out of electronics box.
Unfasten grommets (3) on housing, lay wiring harnesses to one
side.
Installation:
Make sure that grommets are correctly seated in housing
(watertightness).
Unlock cover (4) and remove.
Pull control unit (5) out of electronics box.
Unlock plugs (1) using slide in direction of arrow and disconnect.
Place control unit to one side.
Unlock plug (1) and remove from carrier plate (2).
Unlock relay/engine fuses (3) and detach from plugs.
Press locking tabs (1) in direction of arrow and pull contact
carrier (2) out of housing.
RA Replacing wiring harness section for engine (S54)
BMW AG - TIS
06.02.2013 21:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -