Z Series E85 M roadst (S54) ROADST
Position actuating lever (1) in such a way that it is flush with
mount (2) for connecting pipe.
Hold actuating lever (1) and insert throttle valve assembly until it
rests against engine block.
Tighten down screw connection of corresponding throttle valve
assembly.
Push actuating shaft into bearings or bearing bushings of throttle
valve assemblies. Start on throttle valve assembly 1.
Feed out actuating lever (3) when pushing actuating shaft (1) into
bearings of throttle valve assemblies (2).
Insert fitting screw (1) as illustrated into actuating lever of throttle
valve assembly 1.
RA Removing and installing/sealing a throttle valve assembly (S54)
BMW AG - TIS
06.02.2013 21:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
