Z Series E85 M roadst (S54) ROADST
33 41 000
Replacing drive flange on rear axle shaft (left
or right) (M model)
Special tools required:
•
33 2 116
•
33 2 160
•
33 2 201
•
33 4 041
•
33 4 042
•
33 4 043
•
33 4 045
•
33 4 048
•
33 4 200
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut, activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
lightly and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 3AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove output shaft.
Remove brake disk.
Remove pulse generator.
RA Replacing drive flange on rear axle shaft (left or right) (M model)
BMW AG - TIS
07.02.2013 00:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -