Z Series E85 M roadst (S54) ROADST
Installation:
Pay attention to routing and seating of hydraulic lines.
Release cable holder (1).
Release screw (2).
Tightening torque: 54 31 14AZ
.
Release and remove pin (3).
Unclip cover.
Mark position of screw heads (1).
Release screws and remove main bearing with hydraulic cylinder.
Replacement only:
Screw (1) must be replaced and is supplied with range of space
parts.
Installation:
Fit thin spacer between bracket and frame.
Return screws to original position.
Tighten down bolts.
Tightening torque: 54 31 12AZ
.
Replacement only:
-
Release screws (1) and remove shims (2).
-
If necessary, remove hardtop mounting
RA Removing and installing/replacing hydraulic cylinder for convertible top
BMW AG - TIS
07.02.2013 04:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -