Z Series E85 Z4 2.0i (N46) ROADST
18 00 020
Removing and installing complete exhaust
system (N46)
Special tools required:
•
31 2 220
Warning!
Scalding hazard!
Only perform this work after engine has cooled down.
Necessary preliminary tasks:
•
Remove left tension strut on rear axle
•
Remove reinforcement plate from rear axle
Note:
The reinforcement plate is connected via rubber mounts to the
exhaust system and can remain on the exhaust system during
removal.
Support exhaust system with jack and special tool 31 2 220
and secure against falling out.
RA Removing and installing complete exhaust system (N46)
BMW AG - TIS
08.02.2013 07:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
