Z Series E85 Z4 2.0i (N46) ROADST
Unlock bearing pin (1) in direction of arrow and remove.
Lift out shift arm (1).
Installation:
Grease bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Unfasten screws.
Tightening torque 23 00 1AZ .
Important!
Do not suspend the transmission from the transmission input
shaft during removal and installation as this will deform the
clutch plate. Pull out transmission towards rear and remove.
Installation:
Check dowel sleeves (1 and 2) for correct seating.
Replace damaged sleeves.
Ensure correct position of cover plate.
RA Removing and installing transmission (GS6-17BG)
BMW AG - TIS
08.02.2013 07:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
