Z Series E85 Z4 2.0i (N46) ROADST
•
Slide clamping nut (2) and clamping ring (1) onto tie rod
•
Screw tie rod end onto tie rod to measurement (A)
•
Tighten down clamping nut (2)
Tightening torque 32 21 5AZ
.
After installation:
•
Only if replacing/removing tie rod end: Perform chassis
alignment check
•
Carry out steering angle sensor adjustment
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
08.02.2013 08:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -