Z Series E85 Z4 2.0i (N46) ROADST
51 31 021
Removing and installing/replacing rubber
frame for windshield
Important!
Rubber frame has an aluminum section inlay.
Carefully wind out rubber frame in a turning motion
(windshield breakage).
Raise cowl panel cover (1) slightly.
Pull out rubber frame (2) from left bottom to right bottom.
Note:
Tear-off lip (3) can be stuck on adhesive.
When rubber frame (1) is removed, tear-off lip (3) can tear off
and remain in vehicle.
Installation:
Clean cutout.
If necessary, there is no tear-off lip (3) in area (A).
Pay attention to center marking on rubber frame and windshield.
Replacement of rubber frame without windshield removal:
Detach tear-off lip (3) from rubber frame (1).
If adhesive leaks over tear-off lip (3), this area must be cut out
partially.
To facilitate installation, coat rubber frame (1) and body cutout
with water.
Replacement of rubber frame with removed or new windshield:
Fit rubber frame (1) with tear-off lip (3).
2
Aluminum strip
RA Removing and installing/replacing rubber frame for windshield
BMW AG - TIS
08.02.2013 12:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
