Z Series E85 Z4 2.2i (M54) ROADST
51 14 008
Replacing (removing and installing)
number/letter combination on front left or
right side panel
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Note:
Procedure and dimensions are also mandatory for right side, outer
edge of number is then positioned.
Calculate distance (A) from corner of side panel upwards.
Attach adhesive tape (1) from centrepoint of BMW badge to
distance (A).
Mark distance (B) on adhesive tape (1).
Remove liner (protective strip for adhesive surface) from
number/letter combination.
Position number/letter combination up against adhesive tape (1)
and at distance (B) and press down firmly.
Measurements Z4 2.0i to 3.0i:
A) 318 mm
B) 28 mm
Measurements Z4 2.5si and 3.0si:
A) 318 mm
B) 11 mm
M Roadster and M Coupé:
Calculate distance (A) from corner of side panel upwards and
attach adhesive tape (1) horizontally.
Mark distance (B) on adhesive tape (1).
Remove liner (protective strip for adhesive surface) from
number/letter combination.
Position number/letter combination up against adhesive tape (1)
and at distance (B) and press down firmly.
Dimensions:
A) 306 mm
B) 36.5 mm
RA Replacing (removing and installing) number/letter combination on front left or r
BMW AG - TIS
09.02.2013 18:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -