Z Series E85 Z4 2.5i (N52) ROADST
Installation:
After tightening to specified torque, make sure the notch (2) on
the rotary catch is located between the two markings (1) on the
fuel tank.
Installation:
The fuel filter can only be installed in one position.
When installing, make sure lug (1) of fuel filter engages in
corresponding opening on fuel tank.
Always replace seal (2).
Pull off plug (1).
Disconnect lines (2) and (3) from fuel filter.
Note:
Lines (2) and (3) must not be switched round as they have
different diameters.
Fuel filter and pressure regulator together form a single unit and
can only be replaced as such.
RA Removing and installing/replacing fuel filter with pressure regulator
BMW AG - TIS
12.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -