Z Series E85 Z4 2.5i (N52) ROADST
31 10 000
Removing and installing complete front axle
(with spring strut shock absorber)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Necessary preliminary tasks:
•
Secure engine in installation position
•
Remove front assembly underside protection
•
Remove reinforcement plate
•
Remove lower section of steering spindle from steering gear
•
Remove brake caliper on both sides of steering knuckle and
tie back
•
Disconnect plug connection from ride-height sensor
•
Remove stabilizer link on both sides from stabilizer
•
Detach plug connection for pulse generator on both sides
and expose line up to spring strut
•
Remove both brackets for control arm from engine carrier
Important!
Guide spring struts with your hand when lowering and raising
in order to avoid damaging the wheel arches.
After lowering, the spring struts must be aligned to the front
axle carrier and secured in such a way that the ball joints of
the control arms and tie rod ends are not damaged.
Remove spring strut on both sides from spring strut dome
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
12.02.2013 05:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -