Z Series E85 Z4 2.5i (N52) ROADST
51 43 070
Removing and installing/replacing side trim
panel, footwell, on A-pillar, left
Necessary preliminary tasks:
•
Remove front entrance cover strip (inner)
•
Remove trim panel for pedal assembly.
Release screw (1).
Remove hood/bonnet actuating lever (2) in direction of arrow
from panel (3).
Detach mucket (2) in area of panel (5).
Release screws (1).
Unclip panel (5) in direction of arrow from retaining points (4).
Unlock plug connection of switch (3) and disconnect.
Remove trim (5).
Installation:
If necessary, lever out clips (3) remaining in bores.
If necessary, replace faulty clips (3).
Make sure lug (4) is correctly seated in associated mounting.
Position panel (3) preinstalled with clips (1) on associated bores
and clip into place.
Replacement:
Press catches and remove switch (1) in direction of arrow.
RA Removing and installing/replacing side trim panel, footwell, on A-pillar, left
BMW AG - TIS
12.02.2013 10:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -