Z Series E85 Z4 2.5Si (N52) ROADST
If necessary, set eccentric shaft (1) on twin surface to minimum
lift (2).
Secure special tool 11 4 270 with gripping pliers (3) to guide
block (2).
Important!
Special tool 11 4 270 is only secured to guide block.
Adjusting the gripping pliers (3) is not permitted (risk of
damage) on special tool 11 4 270 .
Note:
The oil nozzle must be removed beforehand from cylinder no. 3.
Warning!
Risk of injury in event of incorrect use.
Important!
Incorrect handling risk of damage.
Secure both bearing pins (2) in return spring with knurled
screw (1) on special tool 11 4 270 .
Press special tool 11 4 270 in direction of arrow as far as it will
go.
Release steel screw (2).
To avoid jamming with screw (2) and return spring, it is
necessary when releasing screw (2) to relieve the pretension on
special tool 11 4 270 uniformly.
Important!
Risk of damage to cylinder head thread.
Tightening torque: 11 37 2AZ
.
RA Removing and installing/replacing intermediate levers (N52)
BMW AG - TIS
13.02.2013 08:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -