Z Series E85 Z4 2.5Si (N52) ROADST
Unlock bearing pin (1) in direction of arrow and remove.
Lift out shift arm (1).
Installation:
Grease bearing pin.
Grease,
Refer to BMW Service Operating Fluids.
Unfasten screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws: 23 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws: 23 00 2AZ
.
Important!
Do not suspend the transmission from the transmission input
shaft during removal and installation as this will deform the
clutch plate. Pull out transmission towards rear and remove.
Installation:
Tighten down screws/bolts to specified torque.
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate.
Screw down blue aluminium screws/bolts in accordance with
angle of rotation.
Angle of rotation 23 00 2AZ
.
RA Removing and installing transmission (GS6-17BG) N52
BMW AG - TIS
13.02.2013 10:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
