Z Series E85 Z4 2.5Si (N52) ROADST
Prepare special tool (1) 24 4 161 (A) with shaped section (2)
24 4 165 side (A) to (A).
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Raise bu turning screw (2) and clamp down.
Then tighten down screw (1).
Supporting transmission:
Support transmission with special tools 23 4 050 , 23 0 132
and 00 2 030 .
Secure transmission with tensioning strap (1).
Tasks are described in Transmission bracket.
After completion of work, check transmission oil level.
Unfasten screws (1) and nuts (2).
Remove transmission cross-member.
Tightening torque 24 71 1AZ/2AZ
.
RA Removing and installing automatic transmission (6HP19Z/N52)
BMW AG - TIS
13.02.2013 10:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -