Z Series E85 Z4 2.5Si (N52) ROADST
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
•
Unlock and disconnect plug (1) by turning.
•
Do not touch pins
•
Release cable from retainers
•
Insert special tool 24 2 390 in sealing sleeve.
These tasks are described in Notes on mechatronics.
Important!
Read and comply with important note.
Release screw (1).
Disconnect hydraulic lines (2) to transmission fluid cooler.
Installation:
Replace sealing rings.
Detach holder from transmission fluid lines on transmission sump.
RA Removing and installing automatic transmission (6HP19Z/N52)
BMW AG - TIS
13.02.2013 10:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -