Z Series E85 Z4 2.5Si (N52) ROADST
33 32 076
Removing and installing/replacing top left
control arm
Note:
If the upper control arm is detached from the rear axle
carrier/trailing arm, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove coil spring
•
Remove rear differential
Unfasten nut.
Remove screw towards rear.
Installation:
Observe bolt insertion direction (F = direction of travel).
Tightening torque 33 32 24AZ
.
Unfasten nut.
Remove screw towards rear.
Remove upper control arm at side.
Installation:
Observe bolt insertion direction (F = direction of travel).
Tighten bolt in normal position.
Tightening torque 33 32 14AZ
.
RA Removing and installing/replacing top left control arm
BMW AG - TIS
13.02.2013 12:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -