Z Series E85 Z4 2.5Si (N52) ROADST
33 32 086
Removing and installing/replacing bottom left
control arm
Special tools required:
•
26 1 040
•
33 4 420
Note:
If the lower control arm is detached from the rear axle
carrier/trailing arm, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove rear wheel
•
Remove stabilizer from rear axle carrier
S54:
•
Remove propeller shaft on final drive.
M54:
Remove exhaust system.
Remove tunnel thermal insulation.
Release threaded ring several turns with special tool 26 1 040 .
Tightening torque 26 11 3AZ
.
RA Removing and installing/replacing bottom left control arm
BMW AG - TIS
13.02.2013 12:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
