Z Series E85 Z4 2.5Si (N52) ROADST
34 52 525
Replacing one front pulse generator
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Open plug housing (1), pull plug connection (2) out of fixture
and disconnect.
Pull cable with rubber grommet from fixture on spring strut and
body.
Installation:
Ensure proper locking of plug connector and proper seating of
rubber grommets.
Release socket head cap screw (1).
Withdraw wheel speed sensor (2) from bore hole.
Installation:
Tightening torque 34 51 6AZ
.
Installation:
Clean bore hole for pulse generator and grease with Staburags
NBU 12/K lubricating grease (refer to BMW Service Operating
Fluids).
RA Replacing one front pulse generator
BMW AG - TIS
13.02.2013 13:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -