Z Series E85 Z4 2.5Si (N52) ROADST
65 77 720
Removing and installing/replacing left B-pillar
sensor (build date up to 12/2005)
Warning!
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Disconnect battery negative lead and cover
•
Remove front left entrance cover strip
•
Remove rear left lower side trim section
Unlock plug connections (1) and disconnect.
Release screws (2) and remove B-pillar sensor (3) in direction of
arrow.
Installation:
Tightening torque 65 77 5AZ
.
Replacement:
Carry out coding/programming.
Observe following IDC specifications:
•
Programming
•
Coding
•
Car & Key Memory
•
CD "CIP"
RA Removing and installing/replacing left B-pillar sensor (build date up to 12/2005
BMW AG - TIS
14.02.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
