Z Series E85 Z4 2.5Si (N52) ROADST
72 12 000
Removing and installing/replacing airbag
module on passenger side
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove complete right glovebox housing
Release screws (1) and (3).
Remove retaining plate (4) in direction of arrow.
Installation:
Make sure centering element (2) is correctly seated on retaining
plate (4).
Unfasten plug connection (2) and disconnect.
Unlock plug (3) and unclip in direction of arrow from airbag
module (4).
Important!
Secure airbag module (4) against falling out.
Release screws (1) and carefully remove airbag module (4).
Installation:
Replace microencapsulated screws.
RA Removing and installing/replacing airbag module on passenger side
BMW AG - TIS
14.02.2013 00:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
