Z Series E85 Z4 3.0i (M54) ROADST
Secure toothed shaft (4).
Insert pin of toothed shaft (4) into tooth gaps of splines on
camshaft and chain wheel.
Push in toothed shaft (4) until approx. 1 mm of splines can still be
seen.
Note installation direction of corrugated washer (7), "FRONT"
lettering must be visible.
Install corrugated washer, tighten nuts by hand but do not tighten
down fully yet.
Insert screws on exhaust side, initially tighten to approx. 5 Nm
and then slacken off again half a turn.
RA Replacing camshaft (M52TU / M54 / M56)
BMW AG - TIS
15.02.2013 11:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
