Z Series E85 Z4 3.0i (M54) ROADST
Preload tensioning rail with special tool 11 4 220 by rotating
adjusting screw with special tool 00 9 250 or standard torque
wrench to 0.7 Nm.
Preload cup spring slightly by pressing on sensor gear (1) and
tighten nuts by hand.
Important!
Do not tighten down nuts fully.
Remove gasket.
Check dowel sleeves (1) for damage and correct installation
position.
Keep sealing face clean and free of oil.
Important!
Fit special tool 11 6 150 "without gasket" only.
If gasket remains underneath special tool 11 6 150 ,
camshaft timing will be "incorrectly" set.
Attach special tool 11 6 150 "without gasket", tighten nuts by
hand and then tighten down uniformly until special tool
11 6 150 is in full contact with cylinder head.
RA Adjusting camshaft timing (M52TU / M54 / M56)
BMW AG - TIS
15.02.2013 11:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
