Z Series E85 Z4 3.0i (M54) ROADST
11 36 570
Replacing solenoid valve for inlet side on
VANOS adjustment unit
Special tools required:
•
32 2 110
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Check stored fault messages
•
Switch off ignition
Unlock hose (1) and detach.
Unlock plug (2) and remove.
Note:
Once it has been removed, oil drips from the solenoid valve.
Have a cleaning cloth ready.
Make sure no oil drips onto the belt drive. Remove any remnants
of oil immediately with cleaning cloth.
Do not damage oil line when releasing solenoid valve.
Release solenoid valve with special tool 32 2 110 .
Installation:
Tightening torque 11 36 1AZ
.
RA Replacing solenoid valve for inlet side on VANOS adjustment unit
BMW AG - TIS
15.02.2013 11:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
