Z Series E85 Z4 3.0i (M54) ROADST
18 40 030
Removing and installing/replacing both
exhaust manifolds (M54)
Warning!
Scalding hazard!
These tasks should only be carried out on an exhaust system
that has cooled down.
Necessary preliminary tasks:
•
Secure engine in installation position
•
Remove front engine underguard
•
Remove reinforcement plate
•
Remove entire exhaust system
•
Remove bracket between exhaust manifold and transmission
•
Detach grounding cable from body
•
Remove right engine support arm with engine mount
•
Release nuts on heat shield at bottom
•
Remove right tension strut
•
Remove air pump
•
Release heat shield at top and remove
Note:
The oxygen sensors are in danger of being damaged when the
exhaust manifolds are removed and installed.
Remove oxygen control sensors.
RA Removing and installing/replacing both exhaust manifolds (M54)
BMW AG - TIS
15.02.2013 11:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -