Z Series E85 Z4 3.0i (M54) ROADST
12 61 250
Removing and installing/replacing oil
temperature sensor (M54)
Necessary preliminary tasks:
•
Switch off ignition
•
Unfasten oil filter cap to enable engine oil in filter to flow back
into the oil sump.
•
Remove intake filter housing
Installation location: at base of oil filter.
Disconnect plug connection (1).
Unscrew oil temperature sensor.
Important!
Engine oil may emerge when the oil temperature sensor is
removed - have a cleaning cloth to hand.
Catch and dispose of emerging engine oil.
Installation:
Tightening torque 12 61 1AZ.
Screw on oil-filter cover tightly.
Check engine oil level, top up engine oil if necessary.
RA Removing and installing/replacing oil temperature sensor (M54)
BMW AG - TIS
15.02.2013 12:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
