Z Series E85 Z4 3.0i (M54) ROADST
12 61 285
Replacing level switch for engine oil (M62,
M54, S54, M56)
Necessary preliminary tasks:
•
Switch off ignition.
•
Unfasten cover on full-flow oil filter to enable engine oil in
filter to flow back into the oil sump.
•
Drain engine oil.
These operations are described in the section BMW engine
oil service.
Remove reinforcement plate.
Important!
The section Removing and installing reinforcement plate
contains important installation instructions.
Disconnect plug connection (1).
Unscrew nuts (2).
Remove level switch (3).
Installation:
Clean sealing surface on oil sump and replace seal of level switch.
Installation:
Screw on oil-filter cover tightly.
Tightening torque 11 42 2AZ
.
Top up engine oil.
RA Replacing level switch for engine oil (M62, M54, S54, M56)
BMW AG - TIS
15.02.2013 12:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
