Z Series E85 Z4 3.0i (M54) ROADST
Unfasten hose clip (1).
Unlock plug (2) and remove.
Pull hot-film air-mass flow sensor (3) off air intake hose.
Installation:
Observe throughflow direction (4).
Check sealing ring (1) for damage and replace if necessary.
Secure sealing ring (1) in upper air filter housing section.
Attach sealing ring (2) to air-mass flow sensor.
Important!
Risk of damage to measuring electronics.
Installation:
Coat all sealing rings with suitable antiseize agent.
Installation:
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (M54)
BMW AG - TIS
15.02.2013 12:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
