Z Series E85 Z4 3.0i (M54) ROADST
Installation:
Pay attention to adapter sleeves (1 and 2), replace if
necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever and clean.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disk (with a cloth).
Push special tool 21 2 221 onto spline shaft.
Then spread a thin and even coat of grease over entire area
of taper splines (1). Also apply a thin coat of grease in spline
groove and to guide pin (2).
Then detach special tool and install transmission.
Subsequent work on transmission:
Secure transmission (1) with special tool 23 0 170 on assembly
stand 00 1 450 .
RA Removing and installing transmission (GS6-37BZ / H-transmission)
BMW AG - TIS
15.02.2013 13:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
