Z Series E85 Z4 3.0i (M54) ROADST
23 12 050
Replacing radial shaft seal for output flange
(GS6-37BZ / DZ H-transmission)
Special tools required:
•
23 0 020
•
23 2 320
•
23 3 161
•
23 3 162
•
33 1 150
Important!
After completion of work, check transmission oil level.
Use only approved transmission oil.
Failure to comply with this instruction will result in serious
damage to the transmission.
Necessary preliminary tasks:
•
Remove exhaust system
•
Support transmission.
•
Remove transmission cross-member
•
Remove transmission bearing block
•
Unflange propeller shaft from transmission and tie up to one
side
Brace output flange with special tool 23 0 020 .
Release collar nut with special tool 23 2 320 .
Installation:
Mark flange with thermo pin and heat to min. 100
°
C.
Warning!
Scalding hazard! Fit flange wearing suitable protective gloves
only!
Important!
Do not drive on flange.
RA Replacing radial shaft seal for output flange (GS6-37BZ / DZ H-transmission)
BMW AG - TIS
15.02.2013 13:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
