Z Series E85 Z4 3.0i (M54) ROADST
Lever out shift sensor (1) upwards at an angle.
Unclip cable.
Installation:
Fit shift sensor (1) downwards at an angle and turn
counterclockwise until installation position is reached.
Important!
Risk of damage:
When fitting shift sensor (1), make sure that lever (2)
engages in groove (3) on selector rod.
Removing selector sensor:
Unfasten screws.
Tightening torque 23 41 11AZ
.
Turn selector sensor (1) counterclockwise slightly.
Installation:
Replace screws.
Lever out selector sensor (1) upwards at an angle.
Unclip cable.
RA Replacing shift and/or selector sensor GS6S37BZ (SMG)
BMW AG - TIS
15.02.2013 13:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
