Z Series E85 Z4 3.0i (M54) ROADST
24 53 002
Removing and installing or replacing parking
lock (A5S 325Z)
Note:
After completing work, top up ATF level.
Check/top up fluid level in automatic transmission,
refer to 00 11 500.
Transmission oil sump removed.
Remove and install transmission oil sump,
refer to 24 11 003.
It is absolutely essential to use the approved automatic
transmission fluid in this automatic transmission,
refer to BMW Operating Fluids MG24.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Installation:
Check function of parking lock.
Move selector lever into "P" setting.
Check whether parking lock is engaged by rotating Cardan
shaft or by pushing car.
Push in detent disk (1) in direction of arrow up to stop.
Unfasten screws (2).
Remove guide bracket (3).
Tightening Torque,
refer to Technical Data 24 34 3AZ.
Unscrew bolt (1).
With an offset tool (2) (e.g. hexagon socket screw key 5 A/F),
push out guide pin of locking pawl (4).
Remove spring (3) and locking pawl (4).
Tightening Torque,
refer to Technical Data 24 34 9AZ.
RA Removing and installing or replacing parking lock (A5S 325Z)
BMW AG - TIS
15.02.2013 14:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
