Z Series E85 Z4 3.0i (M54) ROADST
32 11 000
Removing and installing/replacing steering
gear
Necessary preliminary tasks:
•
Remove front wheels
•
Remove reinforcement plate
•
Remove tie rod end on both sides from swivel bearing
•
Remove lower section of steering spindle from steering gear
•
Replacement only:
-
Remove tie rod end at both ends of tie rod
Release nuts and remove screws towards bottom.
Remove steering gear towards front.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
RA Removing and installing/replacing steering gear
BMW AG - TIS
15.02.2013 15:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -