Z Series E85 Z4 3.0i (M54) ROADST
Necessary preliminary tasks:
•
Remove propeller shaft from rear differential drive flange,
remove complete propeller shaft if necessary
Removing drive flange:
Support rear axle carrier at front middle with workshop jack.
Release nuts and remove compression strut.
Installation:
Replace self-locking nuts.
Tightening torque 33 33 3AZ
.
Important!
Before releasing collar nut, mark drive flange (3) and collar
nut (2) to drive shaft (3) with centre punch or colour marker
pen.
Brace drive flange with special tool 23 0 020 and release collar
nut.
RA Replacing shaft seal for input flange on final drive
BMW AG - TIS
15.02.2013 16:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -