Z Series E85 Z4 3.0i (M54) ROADST
33 32 160
Removing and installing / replacing
compression strut for rear axle carrier
Important!
Observe safety instructions for raising the vehicle
Driving without the compression strut is not permitted!
Necessary preliminary tasks:
•
Remove exhaust system.
•
Remove tunnel thermal insulation
Important!
Risk of damage!
Support rear axle carrier at front middle with workshop jack.
Release nuts and remove compression strut.
Secure rear axle carrier by screwing on nuts.
Installation:
Replace self-locking nuts.
Tightening torque 33 33 3AZ
.
Replacement:
Modify bracket for tunnel heat insulation.
RA Removing and installing / replacing compression strut for rear axle carrier
BMW AG - TIS
15.02.2013 16:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
