Z Series E85 Z4 3.0i (M54) ROADST
34 41 220
Removing and installing/replacing all
handbrake shoes
Special tools required:
•
32 1 030
•
34 4 000
Necessary preliminary tasks:
•
Remove rear brake disks
After completing tasks, adjust handbrake.
Unclip handbrake lever trim (1) at rear and tilt forwards.
Lock adjuster unit (ASZE).
Using special tool 32 1 030 , press stop (2) of adjusting spring
back to such an extent that retaining hook (3) engages in
stop (2).
Disconnect return spring (1) with brake spring pliers.
Installation:
Check and if necessary replace return spring (1).
Figure illustrates right side: left side is mirror image of this.
Pay attention to installation position of adjustment screw (2).
Apply a thin coat of grease to bush and screw threads,
Refer to BMW Service Operating Fluids.
RA Removing and installing/replacing all handbrake shoes
BMW AG - TIS
15.02.2013 22:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
