Z Series E85 Z4 3.0i (M54) ROADST
34 52 516
Removing and installing/replacing control
unit for DSC
Special tools required:
•
32 1 280
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection)!
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove front left wheel
•
Remove front left wheel arch trim
First read out fault memory of control unit and if necessary print
diagnostic record.
Installation:
On completion, carry out following tasks with the DIS (Diagnosis
and Information System):
•
If control unit is new:
-
Coding
-
Adjustment of steering angle sensor
-
Adjustment of pressure sensors
-
Adjustment of transversal acceleration sensors
-
Function check, hydraulic unit
RA Removing and installing/replacing control unit for DSC
BMW AG - TIS
15.02.2013 22:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
