Z Series E85 Z4 3.0i (M54) ROADST
Important!
Removing pump motor from valve block is not permitted!
Disconnect plug connection (1).
Attach special tool 32 1 280 over pump motor and valve block.
Attach retaining clip 32 1 280 first at bottom and then at top over
valve block.
Note:
Arrow (1) on special tool 32 1 280 must point downwards.
Release screws (2) and remove.
Installation:
Tightening torque, 34 51 1AZ
.
Carefully detach control unit (1) from valve block (2).
Move control unit to rear and then remove to the side through
wheel arch.
RA Removing and installing/replacing control unit for DSC
BMW AG - TIS
15.02.2013 22:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
