Z Series E85 Z4 3.0i (M54) ROADST
34 52 555
Removing and installing/replacing pressure
sensor "H" for DSC
Note:
Read and comply with General Information.
Important!
The pressure sensor is omitted from cars after model year
01/06.
After replacing the pressure sensor, carry out an adjustment
with DIS (Diagnosis and Information System) under menu
item "Service functions".
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Disconnect brake pipe from connection with brake hose.
Unfasten plug connection (1).
Detach pressure sensor (2) from master brake cylinder (3).
Installation:
Tightening torque 34 51 2AZ
.
RA Removing and installing/replacing pressure sensor "H" for DSC
BMW AG - TIS
15.02.2013 22:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
