Z Series E85 Z4 3.0i (M54) ROADST
Secure trim (2) with screws (1).
Note:
Seal must rest correctly on trim and under rubber guide (see
previous work step).
Secure seal (2) with screws (1) on left and right.
Feed in seal (2) in trim (3) over entire length.
Attach 6 mm dia. butylene tape between seal (1) and trim
strip (2) according to measurement (A).
A = 75 mm
Fit seal (1) on A-pillar.
Note:
Seal (1) must be seated in area (3) without gap on trim
strip (2).
Feed in seal (1) at bottom correctly in door seal.
Detach liner* in area (A) from seal (1) and stick to A-pillar.
*Liner is protective film for adhesive tape
RA Removing and installing/replacing cowl panel seal
BMW AG - TIS
16.02.2013 00:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
