Z Series E85 Z4 3.0i (M54) ROADST
54 31 130
Removing and installing/replacing one funnel
Necessary preliminary tasks:
•
Remove convertible top
•
Remove mounting for convertible top compartment middle.
•
Remove rear trim from rollover protection system
•
Remove wheel arch splash guard
Remove expansion rivets (1).
Remove clamp (2).
Raise cover (2) slightly and feed out funnel (1).
Lever out funnel (1) towards top.
Expose water drain hose at bottom of wheel arch (remove
underbody protection) and feed out towards top.
Installation:
Install water drain hose with aid of a wire and install feed at bottom
into sheet metal. Ensure correct seating.
Seal water drain hose with extrudable seam seal or underbody
protection at bottom.
RA Removing and installing/replacing one funnel
BMW AG - TIS
16.02.2013 02:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
