Z Series E85 Z4 3.0i (M54) ROADST
63 25 000
Removing and installing/replacing additional
stop light
Open trunk lid.
Loosen screws (1).
Feed out cover (2) in direction of arrow, unlock plug connection
of auxiliary brake light behind it and disconnect.
Pay attention to springs underneath when releasing nuts (3).
Installation:
Tightening sequence of screws:
•
1. Middle
•
2. Outer
Tightening torque, 63 25 1AZ
.
Pull auxiliary brake light (1) in direction of arrow out of rear
lid (2) and remove.
Installation:
Make sure auxiliary brake light seal is correctly seated.
If necessary, replace auxiliary brake light seal.
RA Removing and installing/replacing additional stop light
BMW AG - TIS
16.02.2013 05:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
