Z Series E85 Z4 3.0i (M54) ROADST
Recycling:
Carry out the cleaning operation in a suitable washing bay as the
emerging cleaning agent escapes through the drain openings in
the transmission tunnel.
After completing cleaning, allow car to drip-dry for approx. 5
minutes.
Necessary preliminary tasks:
•
Remove controller for heater - A/C fan
Install special tool 64 1 490 (spraying equipment).
Secure guide (1) in place of controller with screw (2).
Tightening torque 64 11 3AZ
.
Insert spray lance (2) through guide opening (1).
By moving spray lance (2) back and forth, spray a uniform
amount of cleaning agent onto evaporator.
Note:
Set heating - A/C system to footwell ventilation and fresh-air
mode. Open windows/doors.
Start car and run heating - A/C system at maximum fan power for
approx. 5 minutes in order to dry evaporator.
In order to eliminate the last remnants of cleaning agent, repeat
this procedure shortly before handover to the customer.
RA Cleaning evaporator
BMW AG - TIS
16.02.2013 05:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
