Z Series E85 Z4 3.0i (N52) ROADST
Important!
Do not distort conrods or crankshaft.
Use the old conrod bolts to check conrod clearance.
Tighten down conrod bolts with special tool 00 9 120 .
Tightening torque 11 24 1AZ
.
Remove bearing cap. Read off bearing clearance at width of
crushed plastic thread with aid of measuring scale.
Conrod bearing clearance.
•
Remove plastic thread.
•
Coat crankshaft and bearing shells with oil.
•
Install new conrod bolts and tighten down with special tool
00 9 120 .
Tightening torque 11 24 1AZ
.
Assemble engine.
RA Replacing all connecting rod bearings (N52)
BMW AG - TIS
15.02.2013 16:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
