Z Series E85 Z4 3.0i (N52) ROADST
Secure special tool 11 4 283 on cylinder head with screws (1).
Note:
Fit special tool 11 4 282 underneath on inlet side.
Mount special tool 11 4 281 on inlet and exhaust camshafts.
The timings are correct when the part number (2) can be read
from above on the camshafts (1).
With 1st cylinder in firing TDC position, cams of inlet
camshaft (1) at 1st cylinder point upwards at an angle.
With 1st cylinder in firing TDC position, cams of exhaust
camshaft (3) at 6th cylinder point downwards at an angle.
Roller cam follower (1) is not actuated.
Note:
If the timing is checked while the engine is installed, the position of
the camshaft can only be checked with a mirror.
RA Checking camshaft timing
BMW AG - TIS
15.02.2013 16:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
