Z Series E85 Z4 3.0i (N52) ROADST
11 37 030
Removing and installing/replacing eccentric
shaft sensor (N52)
Necessary preliminary tasks:
•
Remove cylinder head cover.
Important!
All bolts are secured against falling out, release bolts (2) on
cylinder head only but do not unscrew fully.
Bolts (2) can fall out.
Risk of damage to timing chain drive.
Release screws (2).
Lift out sensor (1).
Note:
Illustrations show timing chain removed.
Assemble engine.
RA Removing and installing/replacing eccentric shaft sensor (N52)
BMW AG - TIS
15.02.2013 16:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
