Z Series E85 Z4 3.0i (N52) ROADST
Necessary preliminary tasks:
•
Remove underbody protection at front and rear
•
Remove reinforcement plate
Important notes on installation are described in this work step
•
Remove complete exhaust system
•
Remove heat shields and brackets
Disconnect plug connector (1).
Unfasten screws (2).
Remove cover plate (3).
Tightening torque, 24 11 2AZ
.
Installation:
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Aluminium screws must be replaced.
Tightening torque 24 00 2AZ
.
Grip clamping sleeve (1).
Slacken nut (2).
Detach retainer (3) downwards using a screwdriver.
Pull cable (4) out of holder.
Installation:
Adjust selector lever.
RA Removing and installing automatic transmission (6HP19Z/N52)
BMW AG - TIS
15.02.2013 18:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
